GEAR MOTOR MR 977 80

MR97780 ok

 MR977802C 2

 

TIPO  RATIO  L
mm		 *R.P.M. no load
min-1 		  *R.P.M. S 1
min-1		 S1 torque
Nm 		 *R.P.M. S2
min-1 		 S2 torque
Nm 		 Max torque
Nm		 I max
24 Vdc 
MR 977 80 1/4 4 209 710 630 1 510 2,2 8 38
MR 977 80 1/6 6 209 480 430 1,5 350 3,4 12 38
MR 977 80 1/16 16 229 180 160 4 130 8,5 30 38
MR 977 80 1/24 24 229 120 105 6 88 12 45 38
MR 977 80 1/36 36 229 80 70 9 60 19 67 38
MR 977 80 1/64 64 250 45 40 13,5 32 29 102 38
MR 977 80 1/96 96 250 30 26 17 22 43 150 35
MR 977 80 1/144 144 250 20 17 26 15 64/7,2A 150 22
MR 977 80 1/216 216 250 13,5 12,5 30/3A 11,5 64/5,2A 150 15
 MR 977 80 1/216 1296 270
 2,2 2,1 30/1,3A 2 64/1,8A 150 3
 
 
Length "L" of the gearmotor as a funtion of reduction and output number of revolution with the standard motor 977 130 output W 2900 Rpm loadness, 12 or 24 Vdc. Starting corrent 38 A.
 
Drivingshaft supported by self lubrificating bushings. Output shaft supported by two coupled screened bearings.
The motor’s surface and reducer’s surface are both plated to avoid corrosion.
Connecting wires 1 x 300 mm.
 
*The rotation speed can change of ±10%.
 
The S1 load test was made using a (3,8 A) corrent in the air with an increase of temperature of 70° C.
The S2 test was made using a (7,5 A) corrent in the air with a 50% timing 5' with an increase of temperature
of 80° C max.
The starting corrent is (I max) and must not maintained for more than 2".
 
Max load on the extremity of output shaft: Axial 500 N, Radial 600 N
 
Possibility to apply other motor.