GEAR MOTOR MR 756 L 63

MR756L63H ok

 MR752L63 2

 

TYPE  RATIO  L
mm		 *R.P.M. no load
min-1 		  *R.P.M. S 1
min-1		 S1 torque
Nm 		 *R.P.M. S2
min-1 		 S2 toque
Nm 		 Max torque
Nm		 I max
24 Vdc 
MR 756 L 63 1/4 4 168 780 690 0,6 530 1,6 5 22
MR 756 L 63 1/6 6 168 520 460 0,8 350 2,3 7,5 22
MR 756 L 63 1/16 16 188 190 170 2 130 6 18,5 22
MR 756 L 63 1/24 24 188 130 115 3 85 9 28 22
MR 756 L 63 1/36 36 188 85 75 5 56 14 42 22
MR 756 L 63 1/64  64 208 50 44 7,5 32 20 60 22
MR 756 L 63 1/96  96 208 33 30 10,5 22 30 90 22
MR 756 L 63 1/144 144 208 22 20 17 16 40 120 19,5
MR 756 L 63 1/216 216 208 14 13 25 12 54/6A 120 13

 

Length "L" of the gearmotor as a funtion of reduction and output number of revolution with the standard motor
756 L 90 output W 3200 Rpm loadness, 12 or 24 Vdc. Starting corrent 22 A. (44A x 12 Vdc)
 
Drivingshaft supported by self lubrificating bushings. Output shaft supported by two coupled screened bearings.
The motor’s surface and reducer’s surface are both plated to avoid corrosion.
The motor has an electrical suppressor system for the CE standard.
Connecting wires 0,75 x 250 mm.
 
*The rotation speed can change of ±10%.
 
The S1 load test was made using a (3 A) corrent in the air with an increase of temperature of 70° C.
The S2 test was made using a (7 A) corrent in the air with a 50% timing 5' with an increase of temperature
of 80° C max.
The starting corrent is (I max) and must not maintained for more than 2".
 
Max load on the extremity of output shaft: Axial 300 N, Radial 400 N
 
It is possible to apply an encoder.
Possibility to apply other motor.