GEAR MOTOR MR 977 80 Q
|
|
 |
| TYPE | RATIO | L mm |
*R.P.M. no load min-1 |
*R.P.M. S 1 min-1 |
S1 torque Nm |
*R.P.M. S2 min-1 |
S2 torque Nm |
Max torque Nm |
I max 24 Vdc |
| MR 977 80Q 1/96 | 96 | 254 | 30 | 26 | 21 | 22 | 42 | 150 | 38 |
| MR 977 80Q 1/144 | 144 | 254 | 20 | 18 | 31 | 15 | 65 | 230 | 38 |
| MR 977 80Q 1/216 | 216 | 254 | 13,5 | 12 | 45 | 10 | 95 | 345 | 38 |
| MR 977 80Q 1/1296 | 1296 | 274 | 2,2 | 2,1 | 60/1,8A | 2 | 170/3,2A | 400 | 7,5 |
The standard motor 977 130 W output 2900 Rpm loadness, 12 or 24 Vdc. Starting corrent 38 A.
Drivingshaft supported by self lubrificating bushings. Output shaft supported by two coupled screened bearings.
he motor’s surface and reducer’s surface are both plated to avoid corrosion.
Connecting wires 1 x 300 mm.
he motor’s surface and reducer’s surface are both plated to avoid corrosion.
Connecting wires 1 x 300 mm.
*The rotation speed can change of ±10%.
The S1 load test was made using a (3,8 A) corrent in the air with an increase of temperature of 70° C.
The S2 test was made using a (7,5 A) corrent in the air with a 50% timing 5' with an increase of temperature
of 80° C max.
The S2 test was made using a (7,5 A) corrent in the air with a 50% timing 5' with an increase of temperature
of 80° C max.
The starting corrent is I max and cannot be maintained for more than 2".
Max load on the extremity of output shaft: Axial 800 N, Radial 1000 N
Possibility to apply other motor.