GEAR MOTOR MR 742 42 E
TYPE | RATIO | L mm |
R.P.M. no load *min-1 |
R.P.M. S 1 *min-1 |
S1 Torque Nm |
R.P.M. S2 *min-1 |
S2 Torque Nm |
Max Torque Nm |
I max 24 Vdc |
MR 742 42 E 1/4 | 4 | 134 | 900 | 785 | 0,17 | 685 | 0,29 | 1,4 | 5,5 |
MR 742 42 E 1/6 | 6 | 134 | 600 | 554 | 0,25 | 490 | 0,41 | 1,9 | 5,5 |
MR 742 42 E 1/16 | 16 | 148 | 230 | 206 | 0,6 | 164 | 1,12 | 4,2 | 5,5 |
MR 742 42 E 1/24 | 24 | 148 | 150 | 135 | 0,91 | 117 | 1,65 | 6,3 | 5,5 |
MR 742 42 E 1/36 | 36 | 148 | 98 | 82 | 1,4 | 73 | 2,25 | 8,8 | 5,5 |
MR 742 42 E 164 | 64 | 164 | 55 | 49 | 1,9 | 43 | 3,3 | 14 | 5,5 |
MR 742 42 E 1/96 | 96 | 164 | 37 | 33 | 3,1 | 28 | 6,2 | 22 | 5,5 |
MR 742 42 E 1/144 | 144 | 164 | 26 | 22 | 5,8 | 19 | 9,5 | 32 | 5,5 |
MR 742 42 E 1/216 | 216 | 164 | 16 | 14 | 7,7 | 12 | 13,5 | 32 | 3 |
Length “L” of the gearmotor as a funtion of reduction and output number of revolution with the standard motor
737 22 output W 5000 Rpm loadness, 12 or 24 Vdc. Starting current 5,5 A.
This data sheet refers to the version 24 VDC.
Output shaft is supported by two screened bearings. he motor’s surface and reducer’s surface are both zinc plated to avoid corrosion.
Max fload act on the extremity of output shaft: Axial 100 N, Radial 150 N on the extremity of the out put shaft.
*The speed rotation can change of ±10%.
S1 is a continuos work with a maximum current of 1A (1,8 A x 12 Vdc).
S2 is an intermittent work (5’ ON 5’ OFF with a maximum current of 1,7 (3 A x 12 Vdc).
The starting current (I Max) (I max x 12 Vdc 10A) must not mantained for more than 2”.
It is possible to apply an encoder.