GEAR MOTOR MR 735 32
|
|
 |
| TYPE | RATIO | L mm |
R.P.M. no load *min-1 |
R.P.M. S 1 *min-1 |
S1 Torque Nm |
R.P.M. S2 *min-1 |
S2 Torque Nm |
Max Torque Nm |
I max 24 Vdc |
| MR 735 32 1/16 | 16 | 89 | 300 | 250 | 0,22 | 156 | 0,45 | 1,5 | 2,5 |
| MR 735 32 1/64 | 64 | 97 | 75 | 62 | 0,8 | 39 | 1,6 | 3,6 | 2,5 |
| MR 735 32 1/256 | 256 | 105 | 19 | 17 | 2,8 | 10 | 5,5 | 12 | 2,5 |
Length "L" of the gearmotor as a funtion of reduction and output number of revolution with the standard motor
735 13 output W 4700 Rpm loadness, 12 or 24 Vdc. Starting corrent 2,5 A. (5A x 12 Vdc)
735 13 output W 4700 Rpm loadness, 12 or 24 Vdc. Starting corrent 2,5 A. (5A x 12 Vdc)
Output shaft is supported by two coupled screened bearings.
The motor has an electrical suppressor system for the CE standard.
The motor’s surface and reducer’s surface are both plated to avoid corrosion.
The motor has an electrical suppressor system for the CE standard.
The motor’s surface and reducer’s surface are both plated to avoid corrosion.
* The speed rotation can change of ±10%.
The S1 load test was made using a (0,7 A) corrent in the air with an increase of temperature of 70° C.
The S2 test was made using a (1,35 A) corrent in the air with a 50% timing 5' with an increase of temperature
of 80° C max. The starting corrent is (I max) and must be mantained for more than 2".
The S2 test was made using a (1,35 A) corrent in the air with a 50% timing 5' with an increase of temperature
of 80° C max. The starting corrent is (I max) and must be mantained for more than 2".
Max load act on the extremity of output shaft: Axial 100 N, Radial 150 N
It is possible to apply an encoder.