GEAR MOTOR MR 752 63

MR75263 ok

 MR75263 2

 

TYPE RATIO  L
mm		 *R.P.M. no load
min-1 		  *R.P.M. S 1
min-1		 S1 torque
Nm 		 *R.P.M. S2
min-1 		 S2 torque
Nm 		 Max torque
Nm		 I max
24 Vdc 
MR 752 63 1/4 4 151 660 550  0,29 430 0,72 2 7
MR 752 63 1/6 6 151 440 380  0,43 280 1,1 3 7
MR 752 63 1/16 16 171 165 140 1,03 105 2,6 7,2 7
MR 752 63 1/24 24 171 105 90 1,54 70 3,9 10,8 7
MR 752 63 1/36 36 171 70 60 2,3 47 5,8 16,2 7
MR 752 63 1/64  64 191 40 33 3,5 26 8,7 24,3 7
MR 752 63 1/96  96 191 32 26 6 19 13,2 32 7
MR 752 63 1/144 144 191 21 18 8 14 20 55 7
MR 752 63 1/216 216 191 14 11 13 9 29 82 7
MR 752 63 1/1296 1296 211 2 1,9 25/0,8A 1,5 50/1,2A 120 2,3

 

Length "L" of the gearmotor as a funtion of reduction and output number of revolution with the standard motor
752 40 output W 2900 Rpm loadness, 12 or 24 Vdc. Starting corrent 7 A. (14A x 12Vdc)
 
Drivingshaft supported by self lubrificating bushings. Output shaft supported by two coupled screened bearings.
The motor’s surface and reducer’s surface are both plated to avoid corrosion.
The motor has an electrical suppressor system for the CE standard.
 Connecting wires 0,75 x 250 mm.
 
*The rotation speed can change of ±10%.
 
The S1 load test was made using a (1,5 A) corrent in the air with an increase of temperature of 70° C.
The S2 test was made using a (2,8 A) corrent in the air with a 50% timing 5' with an increase of temperature of 80° C max.
The starting corrent is (I max) and must not maintained for more than 2".
 
Max load on the extremity of output shaft: Axial 300 N, Radial 400 N
 
It is possible to apply an encoder.
Possibility to apply other motor.