GEAR MOTOR MVSF B63 L 26
|
|
 |
| TIPO | Rapporto riduzione |
R.P.M. a vuoto *min-1 |
R.P.M. S 1 *min-1 |
Coppia S1 Nm |
R.P.M. S2 *min-1 |
Coppia S2 Nm |
Coppia Max Nm |
I max 24 Vdc |
| MVSF B63 L 26 1/10 | 10,5 | 300 | 270 | 1,8 | 235 | 4,2 | 20 | 45 |
| MVSF B63 L 26 1/15 | 15,5 | 200 | 180 | 2,8 | 160 | 7,5 | 20 | 25 |
| MVSF B63 L 26 1/20 | 21 | 150 | 135 | 3,5 | 120 | 8 | 20 | 25 |
| MVSF B63 L 26 1/30 | 31 | 100 | 90 | 4 | 80 | 9,5 | 20 | 20 |
| MVSF B63 L 26 1/40 | 39 | 75 | 66 | 6 | 64 | 8,5/7A | 18 | 14 |
Gear motor with worm screw and standard motor Ø 63 24 Vdc 3100 RPM loadness 130W.
Starting current: see table I max.
Driving shaft mounted with on 2 ball bearings Output shaft supported by two ball bearings with oil seal on output side.
Connecting wires 2x1 mm2.
*The rotation speed can change of ±10%.
The S1 load test was made using a (5 A) current in the air with an increase of temperature of 70°.
The S2 test was made using (10 A) current in the air with a 50% timing 5’ with an increase of temperature
of 80° max.
The starting current is (I max) and must not maintained for more than 2”.
Max load on the extremity of output shaft: Axial 250 N, Radial 400 N.