GEARMOTOR MR 752 L 63 H
|
|
 |
| TYPE | RATIO | L mm |
*R.P.M. no load min-1 |
*R.P.M. S 1 min-1 |
Torque S1 Nm |
*R.P.M. S2 min-1 |
Torque S2 Nm |
Max Torque Nm |
I max 24 Vdc |
| MR 752 L 63H 1/16 | 16 | 186 | 185 | 160 | 1,7 | 110 | 5 | 13 | 14,5 |
| MR 752 L 63H 1/33 | 33 | 186 | 90 | 77 | 3,8 | 54 | 10,5 | 27 | 14,5 |
| MR 752 L 63H 1/49 | 49 | 186 | 60 | 51 | 5,4 | 36 | 15 | 38 | 14,5 |
| MR 752 L 63H 1/64 | 64 | 206 | 45 | 36 | 7 | 28 | 18 | 45 | 14,5 |
| MR 752 L 63H 1/130 | 130 | 206 | 23 | 20 | 13 | 14 | 35 | 90 | 14,5 |
| MR 752 L 63H 1/195 | 195 | 206 | 15 | 13 | 18 | 9 | 49 | 125 | 14,5 |
| MR 752 L 63H 1/293 | 293 | 206 | 10 | 9 | 26 | 7 | 52/4,5A | 120 | 9,5 |
Gearmotor with input stage with helical gears for noise reduction.
Length "L" of the gearmotor as a funtion of reduction and output number of revolution with the standard motor
752 L 60 output W 3200 Rpm loadness, 12 or 24 Vdc. This data sheet refers to the 24Vdc version. Starting current 14,5 A.
Output shaft is supported by two coupled screened bearings.
The motor has an electrical suppressor system for the CE standard.
The motor’s surface and reducer’s surface are both plated to avoid corrosion.
Connecting 2 wire 0,75 x 250 mm.
* The speed rotation can change of ±10%.
The S1 load test was made using a (2,5 A) current in the air with an increase of temperature of 70° C.
The S2 test was made using a (6 A) current in the air with a 50% timing 5' with an increase of temperature
of 80° C max. The starting current is (I max) and must not mantained for more than 2".
Max load on the extremity of output shaft: Axial 300 N, Radial 400 N
It is possible to apply an encoder.