Bernio - MR 752 52 E

GEAR MOTOR MR 752 52 E

TYPE	Ratio	L mm	*R.P.M. no load min-1	*R.P.M. S1 min-1	Torque S1 Nm	*R.P.M. S2 min-1	Torque S2 Nm	Torque Max Nm	I max 24 Vdc
MR 752 52 E 1/4	4	140	660	550	0,29	430	0,72	2	7
MR 752 52 E 1/6	6	147	440	380	0,43	280	1,1	3	7
MR 752 52 E 1/16	16	155	165	140	1,03	105	2,6	7,2	7
MR 752 52 E 1/24	24	155	105	90	1,54	70	3,9	10,8	7
MR 752 52 E1/36	36	162	70	60	2,3	47	5,8	16,2	7
MR 752 52 E 1/64	64	172	40	33	3,5	26	8,7	24,3	7
MR 752 52 E 1/96	96	179	32	26	6	19	13,2	32	7
MR 752 52 E 1/144	144	172	21	18	8	14	19,5	45	5.5
MR 752 52 E 1/216	216	179	14	11	13,5	10	20/2A	45	3,8
MR 752 52 E 1/384	384	195	8	6,5	15	5	30	65	5,5
MR 752 52 E 1/576	576	195	5,5	4,8	16,5/0,95A	4	31/1,6A	65	3,2
MR 752 52 E 1/867	864	195	3,7	3,1	18/0,75A	2,8	32/1A	65	2,5

Length "L" of the gearmotor as a funtion of reduction and output number of revolution with the standard motor 752 40 output W 2900 Rpm loadness, 12 or 24 Vdc. Starting current 7 A. (14A x 12Vdc)

Output shaft is supported by two coupled screened bearings.
The motor has an electrical suppressor system for the CE standard.
The motor’s surface and reducer’s surface are both plated to avoid corrosion.
Connecting wires 0,75 x 250 mm.

* The speed rotation can change of ±10%.

The S1 load test was made using a (1,5 A) current in the air with an increase of temperature of 70° C.
The S2 test was made using a (2.8 A) current in the air with a 50% timing 5' with an increase of temperature of 80° C max.
The starting current is (I max) and must not mantained for more than 2".

Max load on the extremity of output shaft: Axial 300 N, Radial 400 N

It is possible to apply an encoder.