Cookies help us deliver our services. Using these services, you agree to our use of cookies from this site.

 

GEAR MOTOR MR 763 L 63

MR763L63

MR76363 2

 

TYPE RATIO  L
mm

*R.P.M. no load
min-1 

 *R.P.M. S 1
min-1
S1 torque
Nm 
*R.P.M. S2
min-1 
S2 torque
Nm 
Max torque
Nm
I max
24 Vdc 
MR 763 L 63 1/4 4 193 810 695 1 550 2,2 7 22
MR 763 L 63 1/6 6 193 540 460 1,5 360 3,4 11 22
MR 763 L 63 1/16 16 213 200 170 4 135 8,5 27 22
MR 763 L 63 1/24 24 213 135 115 5,8 90 13 40 22
MR 763 L 63 1/36 36 213 90 77 8,5 60 19 60 22
MR 763 L 63 1/64  64 233 53 45 11,5 35 26 80 22
MR 763 L 63 1/96  96 233 36 31 17 24 38 120 22
MR 763 L 63 1/144 144 233 23 20 25 15,5 55 120 15,5
MR 763 L 63 1/216 216 233 15 13 25/2,7A 12 52/5A 120 10,5

 

Length "L" of the gearmotor as a funtion of reduction and output number of revolution with the standard motor
763 L 110 output W 3200 Rpm loadness, 12 or 24 Vdc. Starting corrent 22 A.
 
Output shaft is supported by two coupled screened bearings.
The motor has an electrical suppressor system for the CE standard.
The motor and the reduction gear are both plated for corrosion strength.
Connecting 2 wire 0,75 x 200 mm.
 
*The speed rotation can change of ±10%.
 
The S1 load test was made using a (3,8 A) corrent in the air with an increase of temperature of 70° C.
The S2 test was made using a (7,5 A) corrent in the air with a 50% timing 5' with an increase of temperature
of 80° C max.
The starting corrent is (I max) and cannot be mantained for more than 2".
 
Max forces which may act on the output shaft: Axial 300 N, Radial 400 N on the extremity of output shaft.
 
It is possible to apply an encoder.
 
 
 
 
 

Bernio Elettromeccanica s.n.c.
P.Iva 00885840967 - C.F. 08007400156