Cookies help us deliver our services. Using these services, you agree to our use of cookies from this site.

 

GEAR MOTOR MR 742 42

MR74242

MR74242 2

 

TYPE RATIO  L
mm
R.P.M. no load
*min-1 
 R.P.M. S 1
*min-1
S1 Torque
Nm 
R.P.M. S2
*min-1 
S2 Torque
Nm 
Max Torque
Nm
I max
24 Vdc 
MR 742 42 1/4 4 134 900 785 0,17 685 0,29 1,4 5,5
MR 742 42 1/6 6 134 600 554 0,25 490 0,41 1,9 5,5
MR 742 42 1/16 16 148 230 206 0,6 164 1,12 4,2 5,5
MR 742 42 1/24 24 148 150 135 0,91 117 1,65 6,3 5,5
MR 742 42 1/36  36 148 98 82 1,4 73 2,25 8,8 5,5
MR 742 42 164  64 164 55 49 1,9 43 3,3 14 5,5
MR 742 42 1/96  96 164 37 33 3,1 28 6,2 22 5,5
MR 742 42 1/144 144 164 26 22 5,8 19 9,5 32 5,5
MR 742 42 1/216 216 164 16 14 7,7 12 13,5 32 3

 

Length "L" of the gearmotor as a funtion of reduction and output number of revolution with the standard motor
742 30 output W 3700 Rpm loadness, 12 or 24 Vdc. Starting corrent 5,5 A.
 
Output shaft is supported by two coupled screened bearings.
The motor has an electrical suppressor system for the CE standard.
The motor and the reduction gear are both plated for corrosion strength.
Connecting 2 wire 0,75 x 250 mm.
 
* The speed rotation can change of ±10%.
 
The S1 load test was made using a (1,2 A) corrent in the air with an increase of temperature of 70° C.
The S2 test was made using a (1,6 A) corrent in the air with a 50% timing 5' with an increase of temperature
of 80° C max. The starting corrent is (I max) and cannot be mantained for more than 2".
 
Max forces which may act on the output shaft: Axial 150 N, Radial 150 N on the extremity of output shaft.
 
It is possible to apply an encoder.

 

 

For further informations please contact our technical department.

 
 
 
 

Bernio Elettromeccanica s.n.c.
P.Iva 00885840967 - C.F. 08007400156