GEAR MOTOR MR 615 30Q
|
|
 |
| TYPE | RATIO | L mm |
*R.P.M. no load *min-1 |
*R.P.M. S1 *min-1 |
S1 Torque Nm |
*R.P.M. S2 *min-1 |
S2 Torque Nm |
Max Torque Nm |
I max 24 Vdc |
| MR 615 30Q 1/4 | 4 | 93 | 1150 | 980 | 0,12 | 860 | 0,21 | 0,68 | 5,4 |
| MR 615 30Q 1/16 | 16 | 101 | 315 | 260 | 0,51 | 221 | 0,88 | 3,1 | 5,4 |
| MR 615 30Q 1/64 | 64 | 110 | 79 | 65 | 1,45 | 58 | 2,35 | 8,6 | 5,4 |
| MR 615 30Q 1/256 | 256 | 118 | 21 | 17,3 | 4,02 | 15 | 6,7 | 10 | 2,1 |
| MR 615 30Q 1/1024 | 1024 | 127 | 5 | 4,5 | 12 | 4,5 | 12 | 12 | 1 |
Length "L" of the gearmotor as a funtion of reduction and output number of revolution with the standard motor 737
22 output W 5000 Rpm loadness, 12 or 24 Vdc. Starting corrent 5,4 A. (10A x 12 Vdc)
22 output W 5000 Rpm loadness, 12 or 24 Vdc. Starting corrent 5,4 A. (10A x 12 Vdc)
Output shaft is supported by two coupled screened bearings.
The motor’s surface and reducer’s surface are both plated to avoid corrosion.The motor has an electrical suppressor system for the CE standard.
The motor’s surface and reducer’s surface are both plated to avoid corrosion.The motor has an electrical suppressor system for the CE standard.
* The speed rotation can change of ± 10%.
The S1 load test was made using a (1 A) corrent in the air with an increase of temperature of 70° C.
The S2 test was made using a (1,7 A) corrent in the air with a 50% timing 5' with an increase of temperature
of 80° C max. The starting corrent is (I max) and must not mantained for more than 2".
The S2 test was made using a (1,7 A) corrent in the air with a 50% timing 5' with an increase of temperature
of 80° C max. The starting corrent is (I max) and must not mantained for more than 2".
Max load on the extremity of output shaft: Axial 200 N, Radial 300 N
Is possibile to apply different motor types with different voltage and RPM and encoder.